铜在空气中生成碱式碳酸铜的热力学分析

从热力学角度研究了酸度、湿度、水的存在状态不同时,单质铜在空气中生成碱式碳酸铜的电动势及其自由能变。通过计算发现:在酸性条件下,p H的大小对于反应的自发性没有影响;大气中二氧化碳溶解达到饱和时,空气湿度增加,反应的自发性略微增加;相同条件下,水由气态变为液态时,反应的自发性增幅较大。     

化学氧化合成聚(苯胺-鲁米诺)复合纳米线的电化学发光特性研究

以过硫酸铵为氧化剂,通过氧化苯胺和鲁米诺混合溶液合成了聚(苯胺-鲁米诺)复合纳米线。相对于鲁米诺425 nm处的最大荧光发射波长,复合纳米线中聚鲁米诺的最大荧光发射波长明显红移到465 nm处。采用简单的滴凃方式将聚(苯胺-鲁米诺)复合纳米线修饰于石墨电极表面,形成一层稳定的聚(苯胺-鲁米诺)复合纳米线膜。此聚(苯胺-鲁米诺)纳米线膜修饰电极呈现出良好的电化学发光特性,H2O2对化学合成的聚(苯胺-鲁米诺)纳米线电化学发光呈现出增敏效应。在优化实验条件下,修饰电极的电化学发光信号与H2O2在5.0×10#9~1.0×10#5mol/L范围内呈线性关系,检出限为2×10#9mol/L。     

Rare Earth Ion Mediated Fluorescence Accumulation on a Single Microbead: An Ultrasensitive Strategy for the Detection of Protein Kinase Activity at the Single‐Cell Level

A single microbead‐based fluorescence imaging (SBFI) strategy that enables detection of protein kinase activity from single cell lysates is reported. We systematically investigated the ability of various rare earth (RE) ions, immobilized on the microbead, for specific capturing of kinase‐induced phosphopeptides, and Dy³⁺ was found to be the most prominent one. Through the efficient concentration of kinase‐induced fluorescent phosphopeptides on a Dy³⁺‐functionalized single microbead, kinase activity can be detected and quantified by reading the fluorescence on the microbead with a confocal fluorescence microscope. Owing to the extremely specific recognition of Dy³⁺ towards phosphopeptides and the highly‐concentrated fluorescence accumulation on only one microbead, ultrahigh sensitivity has been achieved for the SBFI strategy which allows direct kinase analysis at the single‐cell level.     

Electrogenerated chemiluminescence biosensing for the detection of prostate PC-3 cancer cells incorporating antibody as capture probe and ruthenium complex-labelled wheat germ agglutinin as signal probe

A highly selective and sensitive electrogenerated chemiluminescence (ECL) biosensor for the detection of prostate PC-3 cancer cells was designed using a prostate specific antibody as a capture probe and ruthenium complex-labelled wheat germ agglutinin as a signal probe. The ECL biosensor was fabricated by covalently immobilising the capture probe on a graphene oxide-coated glassy carbon electrode. Target PC-3 cells were selectively captured on the surface of the biosensor, and then, the signal probe was bound with the captured PC-3 cells to form a sandwich. In the presence of tripropylamine, the ECL intensity of the sandwich biosensor was logarithmically directly proportion to the concentration of PC-3 cells over a range from 7.0 × 10² to 3.0 × 10⁴ cells mL⁻¹, with a detection limit of 2.6 × 10² cells mL⁻¹. The ECL biosensor was also applied to detect prostate specific antigen with a detection limit of 0.1 ng mL⁻¹. The high selectivity of the biosensor was demonstrated in comparison with that of a lectin-based biosensor. The strategy developed in this study may be a promising approach and could be extended to the design of ECL biosensors for highly sensitive and selective detection of other cancer-related cells or cancer biomarkers using different probes.     

The first montmorillonite‐supported surface single‐structure titanium complex: synthesis,characterization and catalytic activity in alkene epoxidation

A well‐defined single‐site titanium‐modified montmorillonite (MMT) with only one geometric construction ((?SiO)₃–Ti–NMe₂) was obtained in moderate conditions. Reaction of tetrakis(dimethylamido)titanium with hydroxylated MMT was conducted by surface organometallic chemistry technique, and the surface structure was characterized by in situ Fourier transform infrared spectroscopy, ¹³C cross polarization magic angle spinning nuclear magnetic resonance, X‐ray photoelectron spectroscopy, extended X‐ray absorption fine structure, and elemental analysis. The catalytic activity in alkene epoxidation was evaluated, and the results revealed that the steric hindrance of the substances is responsible for the catalytic activity of the MMT‐supported titanium complex but to the characteristic restricted layer‐like structure of the MMT. Copyright © 2014 John Wiley & Sons, Ltd.     

Two-dimensional MgSiP_2 with anisotropic electronic properties and good performances for Na-ion batteries

Using the global particle-swarm optimization method and density functional theory,we predict a new stable two-dimensional layered material:MgSiP_2 with a low-buckled honeycomb lattice.Our HSE06 calculation shows that MgSiP_2 is an indirect-gap semiconductor with a band-gap of 1.20 eV,closed to that of bulk silicon.More remarkably,MgSiP2 exhibits worthwhile anisotropy along with electron and hole carrier mobility.A ultrahigh electron mobility is even up to 1.29 × 104 cm~2 V ~1 s ~1.while the hole mobility is nearly zero along the a direction.The large difference of the mobility between electron and hole together with the suitable band-gap suggest that MgSiP_2 may be a good candidate for solar cell or photochemical catalysis material.Furthermore,we explore MgSiP2 as an anode for sodium-ion batte ries.Upon Na adsorption,the semiconducting MgSiP2 transforms to a metallic state,ensuring good electrical conductivity.A maximum theoretical capacity of 1406 mAh/g,a small volume change(within 9.5%),a small diffusion barrier(～0.16 eV) and low average open-circuit voltages(～0.15 V) were found fo r MgSiP2 as an anode for sodium-ion batteries.These results are helpful to deepen the understanding of MgSiP2 as a nanoelectronic device and a potential anode for Na-ion batteries.     

Prediction of stable BC3N2 monolayer from first-principles calculations: Stoichiometry,crystal structure,electronic and adsorption properties

In this paper, a novel BC₃N₂ monolayer has been found with a graphene-like structure using the developed particle swarm optimization algorithm in combination with ab initio calculations. The predicted structure meets the thermodynamical, dynamical, and mechanical stability requirements. Interestingly, the BC₃N₂ plane shows a metallic character. Importantly, BC₃N₂ has an in-plane stiffness comparable to that of graphene. We have also investigated the adsorption characteristics of CO₂ on pristine monolayer and Mo functionalized monolayer using density functional theory. Subsequently, electronic structures of the interacting systems (CO₂ molecule and substrates) have been preliminarily explored. The results show that Mo/BC₃N₂ has a stronger adsorption capacity towards CO₂ comparing with the pristine one, which can provide a reference for the further study of the CO₂ reduction mechanism on the transition metal-functionalized surface as well as the new catalyst’s design.     

高中生如何解元素推断题

研究高中生如何解元素推断题能加深对化学问题解决的认识。用整群随机抽样法,以海南省某中学高二和高三年级各一个班的学生为被试,以改编的高考元素推断题为工具,用NVivo分析学生解题的书面报告,发现元素的解法和顺序有多种类型。这种多样性由不同的问题表征方式和解决策略引起。对课程与教学的启示:采用科学表征,并促进学生科学表征建构;重视问题解决的算法,矫正启发法造成的偏差。     

以史为鉴——化学科普中的人文素养教育

中国古代历史中蕴含着丰富的化学史资源,对这些资源的挖掘、解读,形成化学科普题材,既是化学教育的需要,也是加强思想政治教育背景下课程思政的现实要求。以寒食散为例,探讨中国古代化学史资源所蕴含的人文素养教育价值,认为化学科普中汲取历史资源,不仅增加了科普的趣味性,有利于向公众普及化学知识,还有助于公众树立正确的世界观和价值观。     

过渡态理论在化学体系中的2个应用实例*

在大学本科一二年级的物理化学教学中,化学动力学章节的学习涉及到对不同时间尺度的认识。本文利用过渡态理论得到的速率常数表达公式,以乙烷分子碳/碳单键旋转和水分子氢键交换的动力学过程为例,对这2个应用实例的动力学过程所发生的时间尺度做出估算。这些时间尺度的估算对于学生理解不同动力学过程的物理图像至关重要,同时也有助于加强学生对重要公式的理解并能够将这些公式在化学体系中灵活运用。